The Question: Intermittent loss of oil pressure
By John's Auto Repair on 1/28/2015 - Last updated: 1/31/2015
Your Answer: I would pull the oil pan and see if the pickup tube has a blockage at the ...
on 1/31/2015
2
The Question: HVAC air flow problems...
By Chris_W on 2/10/2014 - Last updated: 12/18/2014
Your Answer: Check the blower motor itself by running temporary 12 volt jumper lead and ...
on 12/18/2014
7
The Question: it wont start it will turn over theres no power getting to the pump
By Gene Stocking on 11/26/2014 - Last updated: 12/10/2014
Your Answer: Have you plugged in a code reader to see what fault codes are stored? This ...
on 12/10/2014
3
Your Answer: We have to start over. Tell me how you know that there is no power going to ...
on 12/9/2014
The Question: why is my car vibrating
By helpme on 12/5/2014 - Last updated: 12/5/2014
Your Answer: It seems that you may be detailing a collapsed upper right motor mount. If ...
on 12/5/2014
1
The Question: How to remove front drive shaft.
By John's Auto Repair on 12/5/2014 - Last updated: 12/5/2014
Your Answer: I also have been working on cars for about 40 years, but I do not have any ...
The Question: What can cause intermittent S32 fuse (20 amp) position open circuit failures?
By Jimm on 11/22/2014 - Last updated: 12/24/2014
Your Answer: Hi Jim. The reference to "S32" is throwing me some. All wiring diagrams I ...
on 11/23/2014
The Question: No crank, no start condition
By Jimm on 9/27/2014 - Last updated: 10/9/2014
Your Answer: Check fuse # 102 and confirm that the fuse is not blown before I continue. ...
on 9/27/2014
5
The Question: Ok here is my problem. None of my power windows are working, even from there individual switches.
By Michael on 9/3/2014 - Last updated: 9/9/2014
Your Answer: Not likely. There are very few times when the cause of a component (power ...
on 9/9/2014
The Question: 1995 Nissan Altima brake problems
By alex on 9/4/2014 - Last updated: 9/7/2014
Your Answer: So then you are saying that when the brake hose going to the left front ...
on 9/7/2014
Your Answer: Since I'm not there to see I have to confirm a start point. Ok, I am ...
Your Answer: There is a broken wire located in the wioring junction where the driver door ...
on 9/6/2014
Your Answer: You replaced the front caliper? The left side? Confirm that you did not ...
Your Answer: I want to know when this problem began exactly. Example: right after a brake ...
The Question: my car won’t start. not getting spark.
By Pete Palazzolo on 5/24/2014 - Last updated: 5/27/2014
Your Answer: The #1 cause of loss of spark on Honda 1.5 engine is a bad distributor ...
on 5/27/2014
Your Answer: Replace the distributor assembly with reman.
on 5/25/2014
The Question: Can hole in ac pipe be repaired or short pipe replaced?
By AutoMD Member on 5/24/2014 - Last updated: 5/25/2014
Your Answer: I have used JB Weld on a high pressure side aluminum pipe that had a groove ...
The Question: What do I need to replace master cylinder on 2007 Chrysler
Your Answer: No special tool that I know of. It is rare for master cylinders to go bad on ...
The Question: Timing chain and waterpump?
Your Answer: Most likely a bad water pump. Can be replaced without timing chain.
The Question: The starter keeps spinning after the truck has been started and will not stop even after turning the truck off.
By AutoMD Member on 5/23/2014 - Last updated: 5/25/2014
Your Answer: There is a push on wire terminal (RED / LIGHT BLUE) at the starter solenoid ...
4
Feedback form
Your Email Address:
Your comments/suggestions:
Enter the text in the image:
Remember me Forgot Password?
I have read and agree to the AutoMD.com Terms of Use and Privacy Policy.
I agree to receive AutoMD information and announcements by email.
Your account has been created and you are now signed in
The email you entered is not registered with AutoMD.
Please register or sign in with a different email.
Thank You!
Register
An email has been sent to you with directions on how to reset your password