Question: Noise when key turned to on position.

By Rick Shaffer on 4/1/2010 - Last updated: 8/3/2010

Your Answer: When the key is in on position the pump works already. I think it's the ...

answered 8/3/2010

Question: wont stay running/no oil pressure?

By michael on 4/4/2010 - Last updated: 8/3/2010

Your Answer: "Check oil" warning light illuminates? Oil will start to drop if there is a ...

answered 8/3/2010

Question: part number, GM cruise control throttle cable connecting clip?

By NJank on 4/1/2010 - Last updated: 8/3/2010

Your Answer: Here's a pic (just for the link below) an example of a throttle cable clip. ...

answered 8/3/2010

Question: my truck has a new lock cylinder and ignition switch but will not shut off with the key. why?

By joey on 4/5/2010 - Last updated: 8/3/2010

Your Answer: Wrong installation or somethig missing with your Ignition Switch, is your ...

answered 8/3/2010

Question: 2001 Ford Ranger 2.3 L Oil Pressure Switch

By Mark C on 4/1/2010 - Last updated: 8/3/2010

Your Answer: It is screwed to the oil filter adapter located to the oil filter. Refer to ...

answered 8/3/2010

Question: cold air intake for my volvo c30.

By juan mercado on 4/1/2010 - Last updated: 8/3/2010

Your Answer: No it can't affect the engine performance, as a matter of fact, If you ...

answered 8/3/2010

Question: Restricted performance Jaguar 2000 Vanden Plas

By Phil D. on 4/1/2010 - Last updated: 8/2/2010

Your Answer: You have an excessive oil to your # 6 cylinder right! that cause the spark ...

answered 8/2/2010

Question: WOULD A LOOSE OIL FILTER CAP CAUSE ENGINE PROBLEMS

By Taylor on 6/16/2010 - Last updated: 8/2/2010

Your Answer: Yes, to avoid any water and sediments enter to the inside of the filter that ...

answered 8/2/2010

Question: key won't turn in ignition module

By tom on 6/1/2010 - Last updated: 8/2/2010

Your Answer: If the Ignition module is defective, the car will still operates and you can ...

answered 8/2/2010

Question: Engine has no power for several minutes after a cold start.

By Jim Becker on 4/1/2010 - Last updated: 8/2/2010

Your Answer: For further diagnose the problem, you have to check your Ignition system for ...

answered 8/2/2010

Question: Are k&n filters bad for mass air flow sensors

By Jack on 6/25/2010 - Last updated: 8/2/2010

Your Answer: No it's not. In fact, many vehicles uses K/N Air filter kit along with the ...

answered 8/2/2010

Question: Seems to start fine, sometimes shutters a little at first, sometimes not, then after it has been driven for about 10 mil

By malaynes on 6/17/2010 - Last updated: 8/2/2010

Your Answer: Check for a clogged Air filter and probably a weak Ignition coil to one of ...

answered 8/2/2010

Question: car dies after warming up.

By jaxson on 4/29/2010 - Last updated: 8/2/2010

Your Answer: A bad ignition system components. You have to check your plugs, wires ,coils ...

answered 8/2/2010

Question: My car will not start with the gear shift (keyless). I have to use the key to start.

By carole on 4/1/2010 - Last updated: 8/2/2010

Your Answer: Make sure that the lever is in park position when starting, if the lever is ...

answered 8/2/2010

Question: dionosed engine light that came on,dionostic machine said check fuse ? but since then it went off and hasn't been on .

By leo allaire on 5/10/2010 - Last updated: 8/2/2010

Your Answer: It just an error codes if there's no malfunctioning happened to your car. ...

answered 8/2/2010

Question: temperature gauge running close to the red mark on startup

By mewilliams on 5/7/2010 - Last updated: 8/2/2010

Your Answer: It means that there's a problem in your cooling system. Don't let the needle ...

answered 8/2/2010

Question: Messed up acceleration

By mike d on 5/6/2010 - Last updated: 8/2/2010

Your Answer: It could be a bad 02 sensor as you replaced the CAT already, you have to ...

answered 8/2/2010

Question: my jimmy makes loud squeaking noises when i go over bumps.

By milqtoast on 5/2/2010 - Last updated: 8/2/2010

Your Answer: It could be the bearings, but where is the squeaking came from (front ...

answered 8/2/2010

Question: code 32 egr system problem

By Rebecca on 5/1/2010 - Last updated: 8/2/2010

Your Answer: Yes, Code 32 means that you have problem in your EGR system, it could be ...

answered 8/2/2010

Question: i just had my fuel pump fixed, now the fuze box blows every fuze i try and put into the fuel pump slot. what wrong?

By harleymike87 on 4/24/2010 - Last updated: 8/2/2010

Your Answer: Did you check the fuse that you've been installing for the fuel pump? It ...

answered 8/2/2010