Nissan Questions and Answers

Post your Nissan question or share what you know by answering questions

• Ask a Question
• All Questions
• Unanswered
• Ask a Question

• 2008 Nissan 350Z Touring 6 Cyl 3.50L Body & Interior - by Rodney Little 1/14/2019 How many shop hours to replace soft top control module Currently convertible top will not move. The sequence starts correctly with the windows lowering and the passenger seat adjust forward. You can also hear the lock actuators attempting to lock or unlock. The top is currently in a position where it is 2 inches from ... 1 answer Answer

---

• 2012 Nissan Altima S 4 Cyl 2.50L Engine - by Abdul Rahman 1/10/2019 I opened and cleaned the throttle body with maf cleaner.on startup the rpm was 2000 and going high. i cleaned my nissan altima 2012 throttle body with mass air flow sensor cleaner. after fixing it back i started the car. my rpm was high around 2000 and rising above.i went to mechanic for scanning it and making the relearn procedure. but the tool of scanning keeps ... 2 answers Answer

---

• 2004 Nissan 350Z Enthusiast 6 Cyl 3.50L Engine - by Zee Man 1/10/2019 How to fix engine cooling system problem My engine temperature gauge keep going up to hot. While it never boils over, the upper radiator hose is always hot, but the lower one on the driver side is cool. Also it radiator fans continuously runs. No engine lights are on and it seems to happen when I drive. I ... 1 answer Answer

---

• 2003 Nissan Xterra SE 6 Cyl 3.30L Transmissions & Drivetrains - by Odie 1/5/2019 Will a bad torque converter clutch solenoid cause complete failure after a OBD code showing the above. I want to find out if by changing the solenoid if it is your opinion that it will solve my issue. It sounds feasible, but I am operating with a very tight budget (fixed income) and the over $200 part will be felt and depressing if ... 1 answer Answer

---

• 1993 Nissan Sentra XE 4 Cyl 1.60L Transmissions & Drivetrains - by Eldritch 1/1/2019 Transmission Service needed on Nissan Sentra XE limited edition In 2015 I bought this care despite feeling a thump when the transmission shifted from 1st to 2nd. I don't drive the car much. I've averaged about 785 miles over the last 3.5 years. A shade tree mechanic told me I just needed a transmission service. He quoted ... 1 answer Answer

---

• 2000 Nissan Maxima GLE 6 Cyl 3.00L Engine - by mark 12/31/2018 Time required to change starter 1 answer Answer

---

• 2016 Nissan Sentra SR 4 Cyl 1.80L Transmissions & Drivetrains - by Ahmrd 12/3/2018 Should I change cvt fluid I have nissan sentra B17 2017 with 133000 km Until now I didint change the fluid of cvt gearbox Should I change it or it is not changable 1 answer Answer

---

• 2016 Nissan Sentra SR 4 Cyl 1.80L Transmissions & Drivetrains - by Ahmrd 12/3/2018 Should I change cvt fluid I have nissan sentra B17 2017 with 133000 km Until now I didint change the fluid of cvt gearbox Should I change it or it is not changable 1 answer Answer

---

• 2016 Nissan Sentra SR 4 Cyl 1.80L Transmissions & Drivetrains - by Ahmrd 12/1/2018 Have I change the cvt oil I have nissan sentra B17 2017 with 133000 km I ask if I must change the CVT oil or it is not changale oil 1 answer Answer

---

• 1992 Nissan Sentra GXE 4 Cyl 1.60L Engine - by Cmoran110200 12/1/2018 1992 Nissan Sentra - temperature gauge does not go up Car is a 1992 Nissan Sentra SGS 1.6L. Its an Australian model so it wasn't available for selection. Mileage: 362,000km In the last week I have noticed the temperature needle does not rise to its normal position (about halfway) even after continuous driving. I ... 1 answer Answer

---

• 2013 Nissan Sentra SV 4 Cyl 1.80L Transmissions & Drivetrains - by sentra2013 11/23/2018 Why is my ca stalling ca starts fine but hesitates to take off can leave it in drive and still wont move for few minutes only has 52000 miles on it 1 answer Answer

---

• 2005 Nissan Altima S 4 Cyl 2.50L Engine - by Dave 11/22/2018 Replaced the crank shaft sensor and still won't turn over. My girlfriend's 05 altima was having problems starting, it would crank but take forever to start sometimes. The check engine light came on and gave the code for the crank shaft sensor. I then learned that this was a common problem and got a new sensor and replaced ... 2 answers Answer

---

• 1997 Nissan Maxima GLE 6 Cyl 3.00L Engine - by Nick Z 11/18/2018 Battery was connected backwards Changed the alternator and son connected the new battery backwards, now don't get nothing when the key is turned on 1 answer Answer

---

• 1997 Nissan Maxima GLE 6 Cyl 3.00L Engine - by Nick Z 11/18/2018 Battery was connected backwards Changed the alternator and son connected the new battery backwards, now don't get nothing when the key is turned on 1 answer Answer

---

• 2014 Nissan Maxima SV 6 Cyl 3.50L Engine - by Dan 11/11/2018 Serpentine Belt Whineing Serpentine belt makes a whineing noise when I accelerate, I've replaced the belt tensioner and inspected other pullies for bearing wear. Not sure what to do next. 2 answers Answer