» View Question
Autopart Mechanic

Autopa ... 5/29/2019

2013 Chevrolet Express 2500 LT 8 Cyl 6.00L


Keeps Your Car Cool with Radiator Fan Assembly

1 Answer

Partsavatar Carparts

Current radiators can cool the engine very well. Although most of the heat delivered by the internal combustion engine is discharged into the environment through the exhaust frame, the remainder of the engine coolant consumption is exhausted through the water jacket and cylinder head of the engine. The hot coolant is then siphoned into the heat sink where heat is exchanged through the radiator core tube into the cooling environment. The heat sink also performs dual duty dispersion friction heat by moving the programmed transmission components through a transmission oil cooler combined with a radiator header.

As you might speculate, rust and scaling inside the radiator tube will really reduce the ability of the heat sink to dissipate heat into the air. Blocking away from the engine caused by dirty coolant or gasket material and sealant also reduces the cooling capacity of the radiator. In addition, the sensitive aluminum heat sink of the heat sink is often damaged by road debris in the air, which further reduces the cooling capacity of the heat sink.

Construction of Radiator

Most of the early vertical flow radiators were made from an upper "cartridge" fuel tank that was repaired to a brass header plate to maintain the radiator core tube installation. The structure of the lower plate and the outlet can are equivalent. Sadly, due to the free use of lead solders, vertical flow brass radiators are overwhelming, expensive and non-ecofriendly.

How to Extend Cooling Capacity?

The cooling capacity of most radiators can be extended by including additional core lines. While a single push radiator can cool a single uprooted engine, hard core applications require up to four columns of core tubes. With regard to expanding cooling capacity, including multi-row core tubes, in most cases, less returns are generated. Therefore, the front area of the heat sink becomes more and more important in determining the cooling capacity. Additional cooling capacity can be achieved by controlling the shape and thickness of the aluminum fins embedded between the core tubes. Nevertheless, when the cooling blade thickness becomes too great, the wind flow through the radiator is reduced at ordinary driving speeds.

When to Change the Radiator?

If there are enough opportunities and mileage, rust, scale and debris will eventually block the core tube of the radiator. Road vibration, thermal stress and pressure cycle may also cause the core tube to rupture due to weak metal. The engine boiler can also lift the mucus from the bottom of the engine water jacket, which will quickly block a more mature radiator, officially filled with rust and scale.

Subsequently, any vehicle over 100,000 miles on the radiator is an ideal candidate for heatsink inspection and evaluation. If the coolant is excessively corroded or the radiator core is too much damage from road debris, then another cooler should be considered for replacement. In order to prevent the stop of the new radiator, the old coolant can best be flushed in each case, since the engine can be reasonably expected before the introduction of a new radiator. When a new coolant is placed, it is often advantageous to introduce 50/50 premixed antifreeze and water. This will guarantee the good execution life of the newly introduced heat sink.


Answer this question

( characters left)

Follow Question

what's this?