Answers

9234 Answers

Question Answers Comments Actions

Question: Why does my car keep blowing cold air with the heat on?

By KEITH on 1/13/2012 - Last updated: 1/21/2012

Your Answer: Did you already check the condition of your thermostat? You should check the ...

answered 1/14/2012

2

0

Question: What is the resistance of the wheel speed sensors supposed to be? Can I get flash codes from the dash?

By loren on 1/13/2012 - Last updated: 1/14/2012

Your Answer: You can get the troublecode from the dash. You have to use a scan tool/code ...

answered 1/14/2012

1

0

Question: heater doesnt get hot

By cindy on 1/13/2012 - Last updated: 1/14/2012

Your Answer: Is the operation of your heater control valve already checked? Check the ...

answered 1/14/2012

1

0

Question: vehicle won't start

By benson t.d. on 1/13/2012 - Last updated: 1/14/2012

Your Answer: First check if you have enough fuel and fuel pressure. Second diagnose your ...

answered 1/14/2012

1

0

Question: Why does my car need jumped?

By Jackie on 1/13/2012 - Last updated: 1/14/2012

Your Answer: I assumed that you also have a new alternator belt. Sounds like you have a ...

answered 1/14/2012

1

0

Question: ABS Light came on while driving. Pulled off road put in Park. ABS light went Off. TRIED TO PUT IN DRIVE BUT STUCK!!

By Explorer 04 on 1/13/2012 - Last updated: 3/18/2012

Your Answer: Hook up a scan tool/code reader on your vehicle capable of reading ABS ...

answered 1/14/2012

4

1

Question: When driving car dies but still has electrical power

By antoniog1 on 1/13/2012 - Last updated: 1/14/2012

Your Answer: Try to clean your MAF sensor. And if possible verify if there's a stored ...

answered 1/14/2012

1

0

Question: car won't start in cold weather.is there a cold start sensor?

By john nimigean on 1/13/2012 - Last updated: 1/14/2012

Your Answer: You have to diagnose your vehicle first with a scan tool/code reader to ...

answered 1/14/2012

1

0

Question: car won't start in cold weather.is there a cold start sensor?

By john nimigean on 1/13/2012 - Last updated: 1/14/2012

Your Answer: You have to diagnose your vehicle first with a scan tool/code reader to ...

answered 1/14/2012

1

0

Question: How much would repairs cost on this part?

By Devise91 on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Try the AutomD Negotiator ( http://www.automd.com/negotiator/) feature on ...

answered 1/13/2012

1

0

Question: Replace. Water pump on a 2000 Nissan altima

By german gutierrez on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Installation Be certain that all gasket surfaces are clean and properly ...

answered 1/13/2012

3

0

Question: Replace. Water pump on a 2000 Nissan altima

By german gutierrez on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Removal You should disconnect the negative battery cable. And then drain ...

answered 1/13/2012

3

0

Question: Replace. Water pump on a 2000 Nissan altima

By german gutierrez on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Do you need a replacement part or a how to guide?

answered 1/13/2012

3

0

Question: my heater blower comes on when it wants to or when I switch off and on

By Rodney on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Check the wirings/connection (might be loose) and relay for your blower motor.

answered 1/13/2012

1

0

Question: Do you have shocks for 1998 samurai

By Adrian on 1/13/2012 - Last updated: 1/13/2012

Your Answer: I can't find any 1998 Suzuki Samurai coil spring. Try to check out this link ...

answered 1/13/2012

1

0

Question: What size wrench is needed to remove the brake calipers to replace the brake pads

By Randall on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Removal Procedure Remove the reservoir filler cap and drain approximately ...

answered 1/13/2012

4

1

Question: What size wrench is needed to remove the brake calipers to replace the brake pads

By Randall on 1/13/2012 - Last updated: 1/13/2012

Your Answer: Use a 7mm allen wrench.

answered 1/13/2012

4

1

Question: When changing a catalytic converter, which O2 sensor is most likely to need replacement? ck engine code says O2 sensor

By Matt on 1/13/2012 - Last updated: 1/20/2012

Your Answer: Hi Matt! Can you post the extracted troublecode, the code will refer to what ...

answered 1/13/2012

3

1

Question: how to remove and replace a camshaft position sensor?

By d a garcia on 10/1/2010 - Last updated: 1/12/2012

Your Answer: Check out this link ...

answered 1/12/2012

2

0

Question: Where is fuel pressure regulator located

By pineman on 1/12/2012 - Last updated: 1/12/2012

Your Answer: You have to remove the intake manifold plenum to access the fuel pressure ...

answered 1/12/2012

3

0