Answers

20 Answers Answers Comments

The Question: hard to start after it set for a 1 or more hours if i uses starting fluit it start wrigth up

By BarBowl3 on 5/13/2010 - Last updated: 7/4/2011

Your Answer: what about when it's cold like in the morning first thing compared to after ...

on 5/18/2010

4

1

The Question: i replaced fuel pump, and it atill wont run

By crystal on 5/8/2010 - Last updated: 5/17/2010

Your Answer: first things to go are the crank positioning and cam positioning sensors

on 5/17/2010

2

0

The Question: Doesnt start on first try

By Phrted on 5/11/2010 - Last updated: 5/17/2010

Your Answer: try tune-up

on 5/17/2010

1

0

The Question: Tach pegged ,rarely moves,does not return to 0 with engine off

By Nightrider on 5/11/2010 - Last updated: 5/17/2010

Your Answer: your truck has a recall on the dash panel. its extended for so many ? yrs ...

on 5/17/2010

1

0

The Question: What is the best air intake to use while towing?

By Curley7714 on 5/11/2010 - Last updated: 5/17/2010

Your Answer: the one on your truck. dont change, it will just be a waste of money, .a ...

on 5/17/2010

1

0

The Question: Where can I find an inexpensive HVAC controller

By hlsander on 5/12/2010 - Last updated: 5/17/2010

Your Answer: If you can take it out I would open it an use a magnifing glass to look at ...

on 5/17/2010

1

0

The Question: TPS (throttle position sensor)

By Dominic on 5/13/2010 - Last updated: 5/17/2010

Your Answer: the TPS its on the trottle body on the engine. the gas pedal is the one you ...

on 5/17/2010

1

0

The Question: hard to start after it set for a 1 or more hours if i uses starting fluit it start wrigth up

By BarBowl3 on 5/13/2010 - Last updated: 7/4/2011

Your Answer: sounds like the fuel presure regulator is bleeding off the presure or fuel pump

on 5/17/2010

4

1

The Question: engine knock sensor

By bud on 5/13/2010 - Last updated: 5/17/2010

Your Answer: why do you need to trouble shoot #2.Did you get the engine wet. if so they ...

on 5/17/2010

1

0

The Question: Why does the gas pedal go all the way to the floor and there's no power at all?

By kathleen on 5/17/2010 - Last updated: 5/17/2010

Your Answer: the computer does this for sever overheating.the cooling system needs ...

on 5/17/2010

1

0

The Question: how to replace knock sensor

By David Johnson on 5/17/2010 - Last updated: 5/17/2010

Your Answer: i think there under the intake manifold and in the gally cover on that ...

on 5/17/2010

1

0

The Question: Truck has Active Fuel Management but I can only get 14mpg on hwy doing 70mph with crusie control

By Antonio Alvarado on 5/16/2010 - Last updated: 5/17/2010

Your Answer: it has no problem thats the gas milage your going to get. I get 12.9 avg.14 ...

on 5/17/2010

1

0

The Question: The truck starts normal when cold, but is hard to re-start after running for a short time. I smell gas.

By David Barker on 5/15/2010 - Last updated: 5/17/2010

Your Answer: if thats not it try the tempature sensor on engine

on 5/17/2010

2

0

The Question: Truck died out while driving and now will crank over but not start?

By Frank615 on 5/16/2010 - Last updated: 6/24/2010

Your Answer: crank positioning sensor i would think. if it died while driving its the ...

on 5/17/2010

3

0

The Question: Rattle, Metal on Metal, Rubbing

By taylorsm on 4/15/2010 - Last updated: 9/28/2010

Your Answer: if it's not a cliking or clunking noise its could be the brake pads rubbing ...

on 5/17/2010

7

2

The Question: How do I change, and where is the Pitman, Idler Arm and lower ball Joint located?

By vhacosta70 on 5/14/2010 - Last updated: 5/17/2010

Your Answer: if you dont know where there at, don't think about changing them.you have to ...

on 5/17/2010

1

0

The Question: somethin is wrong with my rpm

By amado on 4/5/2010 - Last updated: 5/17/2010

Your Answer: there's a recall on dash boards for your truck they have extended the warr. ...

on 5/17/2010

1

0

The Question: knock sensor were it is gose

By amado on 4/5/2010 - Last updated: 5/17/2010

Your Answer: I think on your year the knock sensors are under the intake maifold in the ...

on 5/17/2010

1

0

The Question: Noise from transmission

By Julia Farmer on 4/14/2010 - Last updated: 5/17/2010

Your Answer: it could be a bolt on the flex plate loose or the u-joint bad on drive ...

on 5/17/2010

1

0

The Question: there is no display in the pNDRL or odometer

By bill on 5/13/2010 - Last updated: 5/17/2010

Your Answer: there is a recall and its good for seven yrs

on 5/17/2010

2

0