Answers

29 Answers Answers Comments

The Question: The signal lights blink sometimes other times it doesn't

By Katherine Young on 5/18/2010 - Last updated: 6/30/2010

Your Answer: CHECK YOU FLASHER IT MAY BE STICKING SOUNDS LIKE IT TO ME

on 6/30/2010

2

0

The Question: I here a clunk coming from the front end. I just had my struts and springs replaced

By cshamu on 6/25/2010 - Last updated: 6/30/2010

Your Answer: SOUNDS LIKE INPROPER INSTALLATION. THEY MISSED PUTTING IN A SPACER/WASHER. ...

on 6/30/2010

1

1

The Question: leaking clutch fliud

By teresaholub on 4/2/2010 - Last updated: 6/30/2010

Your Answer: SLAVE CYLINDER LEAKING

on 6/30/2010

1

0

The Question: what is wrong with front end suspetion on drivers side?

By bill on 6/26/2010 - Last updated: 6/30/2010

Your Answer: SOUNDS LIKE YOU HAVE BENT THE LOWER CONTROL ARM ASSEMBLY , WITH THE TIRE ...

on 6/30/2010

1

0

The Question: what will cause the anti lock and brake light come on

By judy on 6/25/2010 - Last updated: 6/29/2010

Your Answer: BAD SENSORS , BAD WIRING , DIRTY EXCITER RINGS/BROKEN , BAD WHEEL BEARINGS ...

on 6/29/2010

2

0

The Question: truck starts when cold, won't start after driving short distance

By stacymae on 6/25/2010 - Last updated: 6/29/2010

Your Answer: YOUR PROBLEM MAY EXSIST FROM A FEW DIFFRENT THINGS. I WILL GIVE YOU THE ...

on 6/29/2010

1

1

The Question: Rear wiper dosn't work. I have checked the fuse.

By Charles Hackler on 6/25/2010 - Last updated: 6/29/2010

Your Answer: YOU HAVE TO MAKE SURE YOU HAVE POWER TO THE SWITCH AND COMING OUT OF THE ...

on 6/29/2010

1

0

The Question: my car wont start. i tried everything. i dont know what the problem is.

By cindie1965 on 6/26/2010 - Last updated: 7/17/2010

Your Answer: I WILL NEED MORE INFO ON WHAT YOU HAVE TRIED AND WHAT THE PROBLEM IS

on 6/29/2010

3

0

The Question: I missing the stuff behind the button for the horn so it can work

By Faery4monte86 on 6/26/2010 - Last updated: 6/29/2010

Your Answer: INSTALL A EXTERNAL MOMENTARY CONTACT PUSH BUTTON SWITCH AND WIRE IT TO THE ...

on 6/29/2010

1

0

The Question: locked trunk/cabin filter

By Stan on 3/27/2010 - Last updated: 7/29/2010

Your Answer: CHECK YOUR OWNERS MANUAL FOR VALET LOCK OUT. RECHECK ELECTRICAL CONNECTION ...

on 6/29/2010

2

0

The Question: My power windows keep coming off the track, when they are lowered or raised. the motor works fine. What parts needed?

By peggy on 6/26/2010 - Last updated: 6/29/2010

Your Answer: YOUR PROBLEM IS WITH THE TRACKS INSIDE THE THE DOOR. THEY MAY HAVE COME ...

on 6/29/2010

1

0

The Question: emc fuse blows when igniction key is turned on. no start HELP/HELP/HELP

By ubanmertz on 6/29/2010 - Last updated: 6/29/2010

Your Answer: BLOWING A FUSE MEANS YOU HAVE A SHORT TO GROUND AT THE POWER WIRE. IN YOUR ...

on 6/29/2010

2

3

The Question: my abs light came on and will not trun off

By stella loera on 6/29/2010 - Last updated: 6/29/2010

Your Answer: your abs light will come on when the system senses a signaling problem from ...

on 6/29/2010

1

0

The Question: Battery keeps draining after a replacement battery has been installed.

By Blazerkid88 on 6/25/2010 - Last updated: 6/29/2010

Your Answer: you have to do a current draw test on the vehicle this is the only way to ...

on 6/29/2010

3

0

The Question: Veh running on 7 cylinders. Shop says alt caused cam and crank sensors to fail. Runs horrible when hot. Any thoughts

By Tim on 6/29/2010 - Last updated: 6/29/2010

Your Answer: ,my thought is your shop is not being straight with you. if your running on ...

on 6/29/2010

1

0

The Question: DOES THE AIR BAG NEED TO BE DIS ASSEMBLED TO REPLACE THE IGNITION LOCK CYLINDER?

By HELAINE REDDING on 4/3/2010 - Last updated: 6/29/2010

Your Answer: yes. if you are going to do this yourself disconnect the batterey for 5 min ...

on 6/29/2010

1

0

The Question: My gas guage keeps bouncing

By Robert on 6/29/2010 - Last updated: 6/29/2010

Your Answer: this condition is caused by a bad float in the tank in most cases. the gas ...

on 6/29/2010

2

1

The Question: my upper radeater hose conector broke off in the manifold how do i get it out

By redd259 on 6/29/2010 - Last updated: 6/29/2010

Your Answer: use a hack saw blade if you have good enough vision of the hole. cut it ...

on 6/29/2010

2

0

The Question: how do you remove a crankshaft pulley ? I have the bolt out , but cannot get it to budge

By jim fling on 6/27/2010 - Last updated: 6/29/2010

Your Answer: you need a harmonic balancer pulley they take a liitle arm to get off do not ...

on 6/29/2010

2

0

The Question: loud clicking near the valve cover

By lisajvm on 4/5/2010 - Last updated: 6/29/2010

Your Answer: try lucas oil additive .

on 6/29/2010

2

0