Answers

213 Answers Answers Comments

The Question: Replaced master cylinder - calipers & bleed brakes front and rear! Now every once in a while the front brakes will drag!

By scott on 6/11/2014 - Last updated: 6/12/2014

Your Answer: try replacing the break hose chrysler products are notorius for this

on 6/12/2014

1

0

The Question: turn over but no start

By scottbrewer on 3/31/2013 - Last updated: 4/2/2013

Your Answer: check that your timing belt has'nt broke or skiped

on 4/2/2013

1

0

The Question: reinstalled motor in truckwhen transmisson bolts are tightend cant turnflexplate to tighten torque converter nuts

By big red on 9/24/2010 - Last updated: 3/27/2013

Your Answer: Are you sure that you have the torque convertor all the way home into the ...

on 3/27/2013

1

0

The Question: Front right brake rotor is only lasting about five thousand miles before warping after replacing calipers &all bushings

By capt rob on 3/26/2013 - Last updated: 3/27/2013

Your Answer: Did you replace the rotor with a new one or have the rotor turned ? Do the ...

on 3/27/2013

1

0

The Question: How to fix a 2003 Cadillac Deville transmission that drags to engage and is burning transmission fluid no visible leak

By hubahabibi1 on 2/17/2013 - Last updated: 3/3/2013

Your Answer: You have internal problems in the tranny more than likely a stuck clutch ...

on 3/3/2013

1

0

The Question: I did a engine swap and now i have the catalytic converteron the passenger side gets red hot and has a little misfire

By mayelingarcia83 on 2/24/2013 - Last updated: 2/28/2013

Your Answer: The cat is junk replace it

on 2/28/2013

1

0

The Question: Do i have a defective oil pump, or do i need to change the oil

By PERRY on 2/26/2013 - Last updated: 2/28/2013

Your Answer: It sounds to me that the oil pick up is cloged more than likely the old ...

on 2/28/2013

2

0

The Question: Transmission shifts hard from first to second. All other shifts are fine.

By chevyblazer41 on 1/10/2013 - Last updated: 2/28/2013

Your Answer: A shift improver kit to the valve body might help along with a fluid & ...

on 2/28/2013

2

0

The Question: my range rover sits crooked and sits higher in the back and wont go up,what is wrong?

By mmotor1624 on 2/28/2013 - Last updated: 2/28/2013

Your Answer: Is it air suspention if so you probablly have a bag leaking in the front ...

on 2/28/2013

1

0

The Question: my 4 wheel drive takes forever to engage, sometimes it doesnt engage at all, other times it pops right in...what could b

By grahamoutdoors on 12/18/2012 - Last updated: 12/30/2012

Your Answer: Check that you have a strong vacuum

on 12/30/2012

2

0

The Question: 4 wheel drive is not working. Also 4 high and 4 low lights are flashing every 2 miles.

By vicdubray on 12/27/2012 - Last updated: 12/30/2012

Your Answer: Check for a vacuum leak . the actuator for the front is pulled in by vacuum ...

on 12/30/2012

1

0

The Question: I replace both headlights for a new clean look and the passenger light power is half power

By jrwagner4 on 11/11/2012 - Last updated: 11/12/2012

Your Answer: Chech the ground wire loose or corroded

on 11/12/2012

1

0

The Question: My car ran out of gas. When I got gas in it started stalling and running rough and won't accelerate

By wendyu on 11/12/2012 - Last updated: 11/12/2012

Your Answer: most auto manufactures that put the electric fuel pumps in the gas tank have ...

on 11/12/2012

2

0

The Question: is there a differance in timing chain fro a regular 5.0 and a 5.0HO eng.

By russell.briggs on 10/27/2012 - Last updated: 10/27/2012

Your Answer: Both engines will bolt in but the firing orders are different . what I mean ...

on 10/27/2012

2

0

The Question: how to remove the front axle nut?

By angling_eddie on 10/24/2012 - Last updated: 10/24/2012

Your Answer: With a socket that fits the nut and a braker bar or a 3/4 inch ratchet and ...

on 10/24/2012

1

0

The Question: What part needs to be replaced to get my car working?

By epskamp824 on 6/28/2010 - Last updated: 10/23/2012

Your Answer: Well it could be the neutral safty switch .Try putting it in neutral and ...

on 10/23/2012

1

0

The Question: My 2002 ford Taurus is making a load clicking sound from front end what is it

By keith on 10/23/2012 - Last updated: 10/23/2012

Your Answer: While driving ,sound louder when turning right or left if this is the case ...

on 10/23/2012

1

0

The Question: 2003 GMC Envoy Water in Oil

By Mareolsson on 10/19/2012 - Last updated: 10/20/2012

Your Answer: I think this has an oil cooler that is attached to the radiator

on 10/20/2012

2

0

The Question: I finally rebuilt my engine but i had this mistake I did as i was feeling up the radiator with water water leaked inside

By Robert on 10/20/2012 - Last updated: 10/20/2012

Your Answer: I hope you had some one instruct you that is firmiliar with engine ...

on 10/20/2012

2

0

The Question: my car wont give any spark, i put new plugs and change the ignition control module, what else could it be

By bula2000 on 10/20/2012 - Last updated: 10/20/2012

Your Answer: Did yuo check the fuse for the ECM ?

on 10/20/2012

1

2