Answers

174 Answers Answers Comments

The Question: After I turn AC off i still hear a hissing noise near the blower motor area.

By Gary on 7/11/2010 - Last updated: 7/11/2010

Your Answer: HCA is on the money. This is normal operation.

on 7/11/2010

3

1

The Question: my 2008 chrysler sebring is stuck in park

By marshmarsh on 7/11/2010 - Last updated: 7/11/2010

Your Answer: The Brake/Transmission Shift Interlock (BTSI) is likely at fault. Try this: ...

on 7/11/2010

3

0

The Question: my car wont start, got code 1492,they auto store it a bad batter temperture sensor, cant find it on my car,do any know

By celeste on 7/11/2010 - Last updated: 7/11/2010

Your Answer: If convertible, the BTS is located on the rear of the frt bumper beam, left ...

on 7/11/2010

1

1

The Question: SPARK PLUG REPLACEMENT

By LARRY on 7/11/2010 - Last updated: 7/11/2010

Your Answer: Under the plastic covers in the center of the valve covers. A 1.1 hr job.

on 7/11/2010

1

0

The Question: My ABS brake's started kicking in every time I apply the brake's, just before coming to a complete stop.

By Brad on 7/11/2010 - Last updated: 7/11/2010

Your Answer: The problem is likely in the frt whl spd sensors. These trucks are notorious ...

on 7/11/2010

1

0

The Question: Any ideas on how to trouble shoot Idle issues?

By quzzeeq on 7/11/2010 - Last updated: 7/12/2010

Your Answer: You sound like you're smart enough to remember the KISS principle (Keep It ...

on 7/11/2010

5

1

The Question: Any ideas on how to trouble shoot Idle issues?

By quzzeeq on 7/11/2010 - Last updated: 7/12/2010

Your Answer: This sounds like a gnd issue. Voltage drop testing of the engine and PCM ...

on 7/11/2010

5

1

The Question: When replacing the timing belt should we replace the water pump also?

By rosieazul on 7/10/2010 - Last updated: 7/11/2010

Your Answer: In my opinion, yes. When installing a new t/belt with fresh tension, a weak ...

on 7/11/2010

2

0

The Question: 1996 Pontiac Grand Am starts rough

By bizzyd26 on 7/10/2010 - Last updated: 7/11/2010

Your Answer: An injector leakdown test needs to be performed. Suspect you have one or ...

on 7/11/2010

1

1

The Question: how to tell which oxygen sensor is bad

By ed on 7/10/2010 - Last updated: 7/11/2010

Your Answer: Code scan. Post codes here.

on 7/11/2010

1

0

The Question: This is a Question on wiring, The horn, back up lights, hazzard, every wire is hooked up, but it does not seem to work.

By gram_wood on 7/11/2010 - Last updated: 7/11/2010

Your Answer: Inspect fusible links at LF engine compartment ahead of L strut tower.

on 7/11/2010

1

0

The Question: how do I take the oil pan off the engine?

By kmarieddsm on 7/10/2010 - Last updated: 7/11/2010

Your Answer: The structural collar at the rear of the pan/trans housing has to come off ...

on 7/11/2010

1

1

The Question: HOW DO YOU REPLACE HO2S11

By DAVE on 7/11/2010 - Last updated: 7/11/2010

Your Answer: HO2S B1S1 is the frt sensor on the rear cyl bank. Access is difficult. You ...

on 7/11/2010

1

0

The Question: got new tires, alignment, caster bolts, everything else tight. pull when accelerating only. steering is tight.

By Dave on 7/10/2010 - Last updated: 7/11/2010

Your Answer: Ah, a classic case of LH-body torque steer! You're on the right track with ...

on 7/11/2010

1

0

The Question: AC is not cooling properly cool but not cold air coming out

By John Van Deman on 7/11/2010 - Last updated: 7/14/2010

Your Answer: Make sure the fan clutch is OK and there's not a bunch of debris stuck ...

on 7/11/2010

2

1

The Question: engine will not switch over to computor timing after starting .

By TREAL on 7/11/2010 - Last updated: 7/11/2010

Your Answer: The ICM (for electronic spark control). Located on the ign coil bracket ...

on 7/11/2010

1

1

The Question: The ATC panel does not work checked all fuses. Wondering if there is anohter relay that needs to be reolaced?

By iceman_j0254 on 7/11/2010 - Last updated: 7/11/2010

Your Answer: If the control head won't light up at all & the fuses are good, then it's ...

on 7/11/2010

1

0

The Question: Why do the fuses for my power outlets keep blowing everytime I replace them?

By Emmie on 7/11/2010 - Last updated: 7/12/2010

Your Answer: A short ckt is present. In this situation, the source of the short is often ...

on 7/11/2010

2

0

The Question: do you have to take the fuel tank out to put in a fuel pump? if so how do we do it. we hava taken the straps off

By kathy Pryer on 7/11/2010 - Last updated: 7/11/2010

Your Answer: No, the tank does not have to be removed for pump replacement. The pump's ...

on 7/11/2010

1

0

The Question: Missing and losing power going up hills.

By Tom on 7/11/2010 - Last updated: 7/11/2010

Your Answer: No, the hole in the fuel tank will not cause this as long as fuel supply is ...

on 7/11/2010

1

0