Answers

21 Answers Answers Comments

The Question: Just replaced my clutch master cylinder and don't know how to bleed it. currently the pedal just goes to the floor

By cruce_travis on 12/21/2012 - Last updated: 12/21/2012

Your Answer: The master cylinder should have been bench-bled before installing. Skipping ...

on 12/21/2012

1

0

The Question: Engine noise when the engine is cold and disapears when it is at normal operating temperature.

By kickstartmusic88 on 12/20/2012 - Last updated: 12/20/2012

Your Answer: The timing belt is most likely stretched out causing a back-lash between the ...

on 12/20/2012

1

0

The Question: i am replacing a starter in my 2000 Toyota 4 runner, on the two electrical cables one has a hard gray plastic cover.

By keohi on 12/18/2012 - Last updated: 12/18/2012

Your Answer: First, disconnect the battery to make sure you don't arc a wire and cause a ...

on 12/18/2012

1

0

The Question: ideals rough when warm

By dvdcam56 on 12/18/2012 - Last updated: 12/18/2012

Your Answer: May need a valve adjustment, but a compression check should be done first to ...

on 12/18/2012

1

1

The Question: HVAC trouble (no category listed for this)

By rosstg04 on 12/18/2012 - Last updated: 12/18/2012

Your Answer: The temp control knob is held in place with a nut, and if allowed to become ...

on 12/18/2012

1

0

The Question: I was driving down the highway and my cars engine started to lose power, but it did not completly sputter out.

By ryan_kevin_williams on 12/14/2012 - Last updated: 12/14/2012

Your Answer: Your car may be under recall for a defective computer. Call your closest ...

on 12/14/2012

1

0

The Question: my 98 camry shifts at high rpm and and have to get off the gas for it to shift to the next gear what could this be

By kuna89 on 12/10/2012 - Last updated: 12/14/2012

Your Answer: Low transmission fluid. These transmissions are not very tolerant of poor ...

on 12/14/2012

1

0

The Question: why does the brake light go off and on

By rbaker81 on 12/11/2012 - Last updated: 12/14/2012

Your Answer: Sometimes the fluid level is right in between good and not good due to fluid ...

on 12/14/2012

1

0

The Question: Why does my car occasionally stall when I’m at a light and sometimes will not start when the engine is hot.

By dorian832 on 12/12/2012 - Last updated: 12/14/2012

Your Answer: The air flow meter is in-line between the air filter box and throttle body. ...

on 12/14/2012

1

0

The Question: What's happening after replacing ignition coils and spark plugs?

By namanimano on 12/12/2012 - Last updated: 12/14/2012

Your Answer: The intake manifold needs to be removed for the coils to be replaced and it ...

on 12/14/2012

1

0

The Question: i have a 1994 toyota camry and it keeps stalling and shutting of when im driving. I think its the ignition coil.

By porkchopvol on 12/12/2012 - Last updated: 12/14/2012

Your Answer: If it runs fine when you are giving it gas and your foot is applying some ...

on 12/14/2012

1

0

The Question: What causes engine to run a little rough when you first start up the car?

By bobby perkins on 12/14/2012 - Last updated: 12/14/2012

Your Answer: We see this a lot with blown head gaskets and/or cracked cylinder heads. ...

on 12/14/2012

1

0

The Question: What causes intermittent missfire and sluggish driveability after going into closed loop mode?

By patrickprater on 12/11/2012 - Last updated: 12/13/2012

Your Answer: If you replaced the CM with a used unit and not new one that could be the ...

on 12/13/2012

1

0

The Question: can you just add stop leak to radiator to fix the heater core?

By huntercox3941 on 12/13/2012 - Last updated: 12/13/2012

Your Answer: Both good answers but have a shop check for electrolysis. It can be checked ...

on 12/13/2012

3

0

The Question: what causes water/antifreeze to leak into the engine oil?

By btrainer3 on 12/12/2012 - Last updated: 12/13/2012

Your Answer: The timing chain guides on these engines are made of plastic and once ...

on 12/13/2012

2

0

The Question: What causes a car to sputter

By gregg on 12/13/2012 - Last updated: 12/13/2012

Your Answer: I would wager that the gas you got was contaminated. When you get gas from ...

on 12/13/2012

1

0

The Question: My 2000 Celica is going through too much gas. It seems like the engine makes a lot of noise due to heavy vibration too

By GareBear on 10/18/2011 - Last updated: 10/19/2011

Your Answer: It may be a dirty Air Flow Meter or more likely dirty injectors. It sounds ...

on 10/19/2011

1

0

The Question: code P0301....mis fire in cylinder one ingnestion coil

By rick on 10/19/2011 - Last updated: 10/19/2011

Your Answer: P0301 is merely telling you that cylinder 1 is not working correctly. In my ...

on 10/19/2011

1

1

The Question: Vehicle has approc: 60000 miles on it. Toyota Dealer told us it was a Fuel pump $1500. Does that sound right $.

By John on 10/19/2011 - Last updated: 10/19/2011

Your Answer: It is possible, but they would have some codes stored in memory or pending ...

on 10/19/2011

2

1

The Question: Check engine code po141

By Mir on 10/19/2011 - Last updated: 10/19/2011

Your Answer: Almost always the oxygen sensor needs to be replaced. This indicates a ...

on 10/19/2011

1

0