Mercury body & interior repair questions and answers
Post your Mercury body & interior question or share what you know by answering questions
Browse Mercury Categories
368 Questions
-
How Do I Remove & Then Replace Damaged Front BumperKen - 2006 Mercury Mountaineer - Body & Interior - 6/29/2012Front bumper is cracked and damaged and needs replacement. -
Where is the ac orifce tube?cougar - 1985 Mercury Cougar - Body & Interior - 6/26/2012not located at evaporator hose conection.
-
6/26/2012 JackIn the evaporator tube where the high side a/c line (smaller line) enters the Evaporator core. You will need to carefully pull it out with needle nose pliers after discharging the system of refridgerant. If it has any metal in it , you will need to replace the compressor and clean out the complete system. Jack. -
6/26/2012 RCIf it's original, it is part of the metal line (three indented notches). They have a replacement kit
-
-
The dirivers side front and back power windows will not operate. I changed the master power switch but that didn't helpJacob - 2003 Mercury Mountaineer - Body & Interior - 6/23/2012I check for broken wires in the door and could not find any. I am getting power to the switch and the ground is good. I have power down to the connector for the motor. I connected the motor directly to the battery and it did not work. I think it is the motor. I ...
-
6/23/2012 HouseCallAutoNot a DIY job if you never did one before. the regulator has to be removed first. This requires drilling out the regulator to glass rivets (yes rivets, special ones too) then requires removing the glass from the door and then the regulator. Other regulator rivets have to be drilled out as well. Have a pro do it.
6/25/2012 JacobThanks. I thought I could just remove the window motor by removing the three bolts that hold it and replace the motor without removing the regulator.
-
-
Front windshield washer dos'nt workArt Humphrey - 1995 Mercury Sable - Body & Interior - 6/19/2012Need to know which replacement modle to order from JCW. Any guidance for instalation would be helpful. Thank you, Art
-
AIR BAG LIGHT IS ON, HOW DO I GET IT TO GO OUT ?mgbg2012 - 1997 Mercury Grand Marquis - Body & Interior - 6/18/2012I GOT IN A WRECK AND THE AIR BAGS DID NOT DEPLOY. BUT THE AIR BAG LIGHT CAME ON, HOW AND WHAT DO I DO TO GET IT TO GO OFF ?-
6/18/2012 raoul_tiestoIf the airbag light its on u may have a fault code in the airbag system.U need to connect the vehicle to a scanner to find out why the light its on.
-
-
No turn signals, brake lights, cruise controlbnores - 1996 Mercury Cougar - Body & Interior - 6/13/2012I replace the turn signal lever switch but still no work
-
Can i replace a two holes door switch by a one hole door switch?wilko - 1993 Mercury Capri - Body & Interior - 6/6/2012a door switch is the device that puts on/off the interior lights as the doors go open/ closed
-
6/6/2012 CVOThe door has two cavities, one for the switch and the other for speaker wiring. If one of them is no use, of course you could replace with the one hole door switch.
-
-
How hard would it be to replace quarter panels on a 1999 grand marquis?Blazinjessejames - 1999 Mercury Grand Marquis - Body & Interior - 6/4/2012I want to pay thousands less if I can complete this job. Front pass. is crumpled but not frame damage. Rear pass. panel.
-
My high beam does not work although the light on the dashboard comes on. What may be the problem?Gladwyn - 1999 Mercury Cougar - Body & Interior - 6/3/2012
-
Overview of replacing turn signal assembly on driver side.Dan_smile - 2006 Mercury Grand Marquis - Body & Interior - 6/1/2012Need to replace turn signal assembly on driver's side. Looks as if only two nuts are holding it on but I can't tell because most of the assembly is behind the windshield washer fluid reservoir. Do I need to access anything else besides the two nuts at the front of ...
-
How do I stop the door ajar sensor from beepingeffie - 2002 Mercury Mountaineer - Body & Interior - 6/1/2012My alarm won't set because door ajar sensor -
My windshield wipers are no longer operable. I replaced the fuse and purchased a new motor. Still nothing. What else?CJ - 1996 Mercury Grand Marquis - Body & Interior - 5/31/2012Not sure what else it could be.
-
5/31/2012 JimmCheck the wiper relay near or inside the fuse panel. Also, check the wiper switch on the instrument panel, and check the wiring and connections.
-
-
Blinking all door lightsnestor - 1997 Mercury Villager - Body & Interior - 5/28/2012clicking sound even you are driving
-
When I turn thermostat knob all the way to total cool, blue area, a clicking noise like a electrical arc is madeidadirector - 2007 Mercury Grand Marquis - Body & Interior - 5/24/2012
-
Power window motor works, but window won't go up or down.J. Tardif - 1994 Mercury Grand Marquis - Body & Interior - 5/19/2012The motor is working and turning the cable that goes to the top of the window. You just hear a sort of clicking noise at the top when the switch is depressed. Is there some sort of gear at the top that makes the window go up and down?-
5/19/2012 Mr. MerrillThere is a metal cable on a plastic pulley, this is a huge problem. Sooner or later the metal cable shreds the pulley. The motor works and everything and the cable moves. but the pulley won't allow the window to move up and down.
You need a new pulley but you can only replace the whole window track that allows the window to go up or down.
I've had to replace 4 in the driver side front door, 2 in the passenger side front door, and the both back doors are bad because of the metal cable on the plastic pulley. If only they used a metal pulley.
Good Luck
4/20/2013 plisa0564what if the cable that goes to the pulley snaps? Mine did and I don't know how to fix this problem. The pulley seems to be intact.
-
