Mercedes-Benz body & interior repair questions and answers
Post your Mercedes-Benz body & interior question or share what you know by answering questions
Browse Mercedes-Benz Categories
783 Questions
-
Where is the Seat Belt Control Module on my 2002 Mercedes Benz Truck ML 500?blewline - 2002 Mercedes Benz ML500 - Body & Interior - 8/4/2012-
8/4/2012 FrankI don't mean to be stupid but, if it's any consolation, I'm trying to figure out where another control module is too. The dam things are everywhere from what i have been told. On your situation though, I have seen those seat belt control modules underneath the driver's seats on other cars. You might want to check that first.
-
-
How much will it cost to replace the fin of the car. that is where the brake light is the light didn't get damagedjulie - 2011 Mercedes Benz ML350 - Body & Interior - 8/4/2012-
8/4/2012 FrankYou need to explain your question better with more details please. I can't understand what you mean by "fin" or brake light issue. Need better explanation.
-
-
Tail gate latch does not want to hook. It acts like something is in the way.suzanne - 2002 Mercedes Benz ML320 - Body & Interior - 7/31/2012
-
My A/C stopped blowing cold air, what could be wrong?ErinAshlee6 - 1999 Mercedes Benz CLK320 - Body & Interior - 7/27/2012I recently wrecked my car, the front passanger side including the fender and headlight were damaged. Directly after I wrecked, my A/C stopped blowing cold air. What are some things that may be wrong with it?
-
My brake light is working one side only and I don't think it's the bulb?tc - 2002 Mercedes Benz CLK320 - Body & Interior - 7/27/2012I change the brake light bulb but still only one side work? -
How can I get to the hydronic jack that operates the convertible top.Sharlene - 1998 Mercedes Benz SL500 - Body & Interior - 7/24/2012The hydronic jack is busted and I don't know how to get to it
-
7/24/2012 JimmYou will have to remove the rear seat and trunk panel from the interior. The hydraulic lift motor is located just behind the rear seat panel and in front of the trunk.
-
-
I have no gauge on dash(no gas temp no speedbenjamin - 2000 Mercedes Benz ML320 - Body & Interior - 7/23/2012No power in insurgent panel -
Replacing release actuator for conv. top. Can you tell me where the hydraulic fluid get's added for this systemdonovan13 - 1999 Mercedes Benz CLK320 - Body & Interior - 7/22/2012Can't find place to fill the hydraulic fluid after replacing the conv. top actuator( Hydraulic system) for the top. It's not in the engine compartment nor in the trunk ?-
7/22/2012 Benice96Yes pump is in between the back seat and the trunk, but you can only get to it if you have the back half of the top up and the boot up at the same time. This is a small space that you have to work in, but you have to remove all of the covers and metal plate to get to it. Good luck
-
7/22/2012 donovan13In the trunk remove the fabric cover on the wall behind the back seat.on the left side is a round hole(small) i used a piece of tubing attached to the hydralic fluid to reach the top of the fill container. you can also remove the bolts on the bottom of the metal frame there and lift it a little to get your hand in there. it's tight but i just did it last month.good luck.
-
-
My EC comes on every time I shut car off and AC want work when I restart it unless I reset it every timeanthonyc - 1999 Mercedes Benz CLK430 - Body & Interior - 7/19/2012AC problems -
Back windows do not go completely down when the top is down. They stand up about 1 inBarbara Cooper - 2009 Mercedes Benz SLK300 - Body & Interior - 7/15/2012Dealer says that is the way it is. Surely not!
-
Why does the top not go down? It makes a clicking noise when I push the button, but it will not release and go down.Wanda - 1994 Mercedes Benz SL320 - Body & Interior - 7/15/2012The top and hydraulics were replaced about 3 years ago. It was working fine until Friday.-
7/15/2012 JimmThe top will not go down if the Windows have lost the Synchronization.
One window at a time, Run the window up and continue to hold the window for an additional 2 seconds. Once you have done this, The the window should do down with one push of the button.
Now, If the windows work in this automatic mode, The top should work as well.
Try this website for further information; http://www.tophydraulicsinc.com./ They also list hydraulic top schematics and instructions.
7/15/2012 WandaJimm: Thank you for responding. I tried your advise, but the top is not going down. The windows go down, when I push the button for the top to go down and they will go up when I push it to put the top back up, but the top is doing nothing. It makes a clicking sound.
-
-
When I turn on the air conditioner, it blows cold for maybe two minutes, then starts blowing heat out.kennyfox - 1997 Mercedes Benz S320 - Body & Interior - 7/13/2012
-
I had something melt to nothing that had wires that where connected to it. it was just below the fuse box under the hoodpittbulacious - 1990 Mercedes Benz 300TE - Body & Interior - 7/13/2012more info on that thing that melted it had a square bracket dill.on the inside of fender onthe drivers side. wires were connected to screws around the shock mount area...
-
What is wrong when retractable hard top does not go down the whole way and what oil do I use for hard topkandi - 2001 Mercedes Benz SLK320 - Body & Interior - 7/12/2012The other day my husband tried to put the hard top down and it started but then stopped after the windows went down and the trunk opened top was about 3/4 way down.
