new

Compare Quotes from TRUSTED Repair Shops

100% Satisfaction Guarantee PLUS 5% Cash Back on Repairs

Available in:
Bakersfield, CA
Spokane, WA
Long Island, NY
Get Quotes
Home » Auto Answers » Transmissions & Drivetrains » Hyundai

Hyundai transmissions & drivetrains repair questions and answers

Post your Hyundai transmissions & drivetrains question or share what you know by answering questions

Browse Hyundai Categories

231 Questions
Sort by:
  • joe
    joe - 2003 Hyundai Elantra - Transmissions & Drivetrains - 5/19/2013
    Have transmission leak change seal still coming out as soon as it gets in seal is in tight
    2003 Hyundai trans mission leaking cant keep fluid in wandering if other than transmission seal new axle was put in plus tie rods
     
    • Jimm
      5/19/2013 Jimm
      Need more information - which type of transmission is on the vehicle; manual or automatic? Second question, which seal is leaking? Is this the output shaft seal on the automatic transmission?

      Is the seal installed in the correct direction? Is the seal damaged, torn or ruptured because of the new axle installation?
  • joe
    joe - 2003 Hyundai Elantra - Transmissions & Drivetrains - 5/19/2013
    Need to know why transmission leaking changed seal new axle leak is bad
     
    • Jimm
      5/19/2013 Jimm
      Need more information - which type of transmission is on the vehicle; manual or automatic? Second question, which seal is leaking? Is this the output shaft seal on the automatic transmission?

      Is the seal installed in the correct direction? Is the seal damaged, torn or ruptured because of the new axle installation?
  • mrastley65
    mrastley65 - 2005 Hyundai Accent - Transmissions & Drivetrains - 4/15/2013
    Engine light comes on car shifts rough
    while driving the car engine light comes on and it start shifting rough both up and down, then light will go off when gas level gets low and it shifts fine until i put gas in it again, then it starts shifting rough again and engine light comes back on. No other ...
     
    • vandiverautoservices
      Hyundai has had several issues with your same problem, best to let dealer or qualified mechanic deal with it. I read TSBs from a full scan of a 2006 with the same issue, had problems connecting to the ECU, which fuel pump, relay, connectors, or wiring may be the issue
  • littlejonb
    littlejonb - 2002 Hyundai Elantra - Transmissions & Drivetrains - 3/30/2013
    What would cause 4th gear to pop out of gear while all other gears are in working order
    I just replaced the clutch in my 2002 hyundai elantra with manual transmittion. All gears are ok with the exception of 4th gear. The gear will engage but as soon as u press the accelerator it is thrown out of gear. With having just replaced the clutch what could be ...
     
    0 answer
  • littlejonb
    littlejonb - 2002 Hyundai Elantra - Transmissions & Drivetrains - 3/30/2013
    What would cause 4th gear to pop out of gear while all other gears are in working order
    I just replaced the clutch in my 2002 hyundai elantra with manual transmittion. All gears are ok with the exception of 4th gear. The gear will engage but as soon as u press the accelerator it is thrown out of gear. With having just replaced the clutch what could be ...
     
    0 answer
  • gonewyld13
    gonewyld13 - 2000 Hyundai Elantra - Transmissions & Drivetrains - 3/24/2013
    At 30-35 mph the vehicle slips btwn 2nd n 3rd gear,,..at 45 mph it will slip in n out of o/d...its fine at hwy speed
    it only has 75k on it but was towed behind a motorhome ...
     
    0 answer
  • gbent227
    gbent227 - 2003 Hyundai Elantra - Transmissions & Drivetrains - 3/16/2013
    I have a 2003 hyundai elantra gt 5 speed. Recently the car has started to slip when shifting gears it has 198,000 miles
    Wondering if slave cylender could cause the slippage or should the entire clutch be replaced. Been slipping for about 3 weeks now. Doesnt appear to be getting any worse.
     
    0 answer
  • charlesboink4
     
    0 answer
  • TOWNMECH1
    TOWNMECH1 - 2004 Hyundai Elantra - Transmissions & Drivetrains - 2/24/2013
    Transmission takes about 5 seconds to go into reverse and their is no sound of slipping
     
    0 answer
  • blk1440
    blk1440 - 2001 Hyundai Sonata - Transmissions & Drivetrains - 2/7/2013
    Rpm high car acceleration seems like it's stalling
     
    0 answer
  • karen_walker_1965
    karen_walker_1965 - 2005 Hyundai Tiburon - Transmissions & Drivetrains - 2/1/2013
    What can cause my car to get stuck in 3rd gear.
    My 2005 Tiburon is starting to have issues. it has 120,000.00 miles and now my check engine light comes on and then off. on the days it is on, I notice it will get stuck in 3rd gear. what could cause this?
     
    0 answer
  • jose gonzalez
    jose gonzalez - 2010 Hyundai Sonata - Transmissions & Drivetrains - 1/28/2013
    Why does my cars transmission shifts down hard when coming to a stop?
    It seems to happen when the car is cold, after you have driven it for awhile and it reaches operational warm temperature, It down shifts normally.
     
    • Jimm
      1/28/2013 Jimm
      First step, check the transmission fluid level and refill as required.
      Jimm
      2/22/2013 jose gonzalez
      Thanks Jim, Checked fluid level it was at the full line when hot. Do you think I should take it in to have the trans filter and oil changed, I have 73,000 miles on it.
  • evashamilton
    evashamilton - 2004 Hyundai Accent - Transmissions & Drivetrains - 1/7/2013
    Can an axle seal cause a carrier bearing to fail?
    My mechanic replaced my axles and the axle seals - then 4 months later the car stopped working. Turns out the axle seals have failed and the entire transmission needs to be replaced/ rebuilt. I have a warranty for the axle seals so it would seem that this warranty ...
     
    0 answer
  • evashamilton
    evashamilton - 2004 Hyundai Accent - Transmissions & Drivetrains - 1/7/2013
    Can an axle seal cause a carrier bearing to fail?
    My mechanic replaced my axles and the axle seals - then 4 months later the car stopped working. Turns out the axle seals have failed and the entire transmission needs to be replaced/ rebuilt. I have a warranty for the axle seals so it would seem that this warranty ...
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2005 Hyundai Tucson - Transmissions & Drivetrains - 12/31/2012
    Hesitation when first giving gas then smooths out and runs fine.
     
    • Jimm
      12/31/2012 Jimm
      First step - have the check engine light or stored fault codes scanned - for free - at any local auto parts store; Advance Auto, Auto Zone, NAPA. Then, post a reply as 'add answer' for more assistance.

      Possible Causes of Engine Hesitation or Stumble:

      Dirty fuel injectors (cleaning the injectors often fixes this)
      Dirty air filter (change filter)
      Dirty / clogged fuel filter (change filter)
      Bad MAP (manifold absolute pressure) sensor
      Bad TPS (throttle position) sensor
      Bad or dirty MAF (mass airflow) sensor
      Low fuel pressure (leaky fuel pressure regulator or weak fuel pump)
      Vacuum leaks (intake manifold, vacuum hoses, throttle body, EGR valve)
      Bad gasoline (fuel contaminated with water or too much alcohol)

      Sometimes, what feels like a hesitation is actually ignition misfire rather than lean misfire. The causes of ignition misfire may include:

      Dirty or worn spark plugs
      Bad plug wires
      Weak ignition coil
      Wet plug wires