Auto Answers » Transmissions & Drivetrains » Honda

Honda transmissions & drivetrains repair questions and answers

Post your Honda transmissions & drivetrains question or share what you know by answering questions

Browse Honda Categories

216 Questions
Sort by:
  • Honda owner
    Honda owner - 2003 Honda Pilot - Transmissions & Drivetrains - 12/20/2014
    Check Engine Light - Error codes P0705, P0706
    Check engine came on so I had someone pull the codes. They came up P0706, P0705. The print out lists it is a short in transmission range switch circuit. It lists possible causes as faulty transmission range switch, open or short circuit condition, poor ...
     
    0 answer
  • Rudy300
    Rudy300 - 1999 Honda Accord - Transmissions & Drivetrains - 12/14/2014
    Transmission is changed but there is a delay in gear when shifting between 3rd and 4th.
    I recently replaced my transmission which is used on my accord 1999 with approx 120,000 km and my 1st and 2nd gear shifts are fine with no trouble but, my 3rd and 4th is delayed where my engine over revs and then shifts after 10 seconds of changing gears. Is it ...
     
    0 answer
  • EricB
    EricB - 2011 Honda CR-V - Transmissions & Drivetrains - 12/7/2014
    Noticeable vibration entire vehicle when stop in traffic or light. RPM drops below 700. What's the cause(s)?
    Only 36,000kms [17,000 miles]. Happens only when vehicle is warm. Started noticing this when the vehicle turn 2 years. No check engine or other warning lights on. I owned 2 of the same model and only one showing this issue. The manufacturer said its normal and is a ...
     
    0 answer
  • robin grigsby
    robin grigsby - 1990 Honda Accord - Transmissions & Drivetrains - 11/29/2014
    While in drive mode S lite comes on panel
    wont shift into regular gear within regular DRIVE mode.
     
    0 answer
  • HelpWithHonda
    HelpWithHonda - 1995 Honda Civic del Sol - Transmissions & Drivetrains - 11/25/2014
    Warranty and parts issue. Advice desperately needed.
    In 2012 a Honda dealership replaced my engine after they blew the original. I recently found out that a transmission part that they would have been replaced by them is too short for my vehicle. I understand that my warranty has long since expired, but this isn't a ...
     
    0 answer
  • tfritz
    tfritz - 2004 Honda Civic - Transmissions & Drivetrains - 11/18/2014
    Car's transmission seemed to be stuck in a low gear when in drive
    its very cold, and snowy and wet. I went to drive my car, started it, and proceeded to clear off the snow and ice. when i went to drive it, it backed out of the spot without issue, and went forward without issue. But as my speed increased, the RPMs went up, but ...
     
    0 answer
  • VN1600A1
    VN1600A1 - 1994 Honda Accord - Transmissions & Drivetrains - 11/9/2014
    Transmission shift mechanism alignment?
    I had to pull the transmission to do a clutch job, something I read told me to take off the shift selector (mechanism/box) from the top of the transmission so it would clear the inner fender. Now I have it put together but the gears aren't lining up, I just need to ...
     
    0 answer
  • cbn02
    cbn02 - 2007 Honda Odyssey - Transmissions & Drivetrains - 10/17/2014
    What's source of car noise?
    recently got 2 new tires. now hear wub-wub-wub when breaking. noise stops as car stops. Sounds like front left wheel. New tires are on the front. Could it be tire? Dealer inspected brakes and found no problems.
     
    0 answer
  • Phil
    Phil - 2000 Honda CR-V - Transmissions & Drivetrains - 10/15/2014
    What is the thumping and grinding noise coming from under centre of car?
    My 2000 crv drives beautifully but when easing off throttle suddenly makes a clunk from under floor pan between front seats. Sometimes a rubbing/ grinding sound and now a grinding sound when in reverse. Could this be a cv joint problem or gearbox?
     
    0 answer
  • zakrya6665
    zakrya6665 - 2004 Honda Accord - Transmissions & Drivetrains - 10/15/2014
    Problem with Transmission or Shift Solenoid???
    I have a Problem with transmitter shifting. I have Honda Accord 2004 4cyl with automatic transmission. Putting gear into D or R gives a Jerk to Car and all gears are shifting on high RPM i.E 3000 RPM. But sometimes, After Running the car for 30 to 40 min and ...
     
    0 answer
  • ransam
    ransam - 1992 Honda Accord - Transmissions & Drivetrains - 9/9/2014
    The drive 4 indicator light flickers or stays on and the car is usually stuck in one gear.
    I replaced the speed sensor but the problem came back. I tried cleaning the pig-tail connection, it seemed to work at first. I noticed that when I disconnected the battery and reconnected the problem would go away for awhile. I hear a clicking under the hood when ...
     
    0 answer
  • ransam
    ransam - 1992 Honda Accord - Transmissions & Drivetrains - 9/9/2014
    The drive 4 indicator light flickers or stays on and the car is usually stuck in one gear.
    I replaced the speed sensor but the problem came back. I tried cleaning the pig-tail connection, it seemed to work at first. I noticed that when I disconnected the battery and reconnected the problem would go away for awhile. I hear a clicking under the hood when ...
     
    0 answer
  • rhkilgour
    rhkilgour - 1992 Honda Accord - Transmissions & Drivetrains - 9/3/2014
    Why will my car shift into 2nd, 4th, and Reverse fine, but will not shift into 1st, 3rd, or 5th?
    The car had been running fine but started becoming difficult to shift until it would not shift into 1st, 3rd or 5th. I replaced the clutch, but it did not fix the problem. It shifts into 2nd and 4th just fine. I am confused.
     
    0 answer
  • Fabian Melgar
    Fabian Melgar - 2008 Honda Fit - Transmissions & Drivetrains - 8/28/2014
    Humming sound under car. Loudest starting at 40 mph. No change whether car is in gear or out of gear.
    Car has 76,000 miles. No other problems.
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2006 Honda Civic - Transmissions & Drivetrains - 6/22/2014
    When installing the shifter cables to the shifter lever or mechanism does it have to be centered with the rods?
    Reason for asking is I've changed the transmission twice and third got locked up. When the lever is on neutral the cables are centered. But when I move the lever into gear lets say third and try to center the cables they aren't centered. Actually the cable going ...
     
    0 answer