Auto Answers » Body & Interior » Dodge » Page 11

Dodge body & interior repair questions and answers

Post your Dodge body & interior question or share what you know by answering questions

1332 Questions
Sort by:
  • AutoMD Member
    AutoMD Member - 1998 Dodge Ram 1500 - Body & Interior - 12/31/2012
    What could be the problem?
    1998 Dodge Ram 1500, 5.9L (360), 172,000 Miles. I have been having an issue for a couple months now and cannot figure out what is the cause of it. At any point in time when I activate the switch for my headlights, I will get a dim and solid lit turn signal (right) ...
     
    • Bill
      12/31/2012 Bill
      Try adding a ground to the headlight assembly, dodges have been known to be eratic if not grounded sufficiently
  • CPike
    CPike - 1998 Dodge Dakota - Body & Interior - 12/30/2012
    Heat doesn't work.
    Need ideas for why when I turn my heat on it only blows cool air.
     
    • CVO
      12/30/2012 CVO
      A. Insufficient coolant , trapped air in the cooling system might not have enough coolant to fully fill the heater core.
      The hot coolant flows from the engine to the heater core through the "inlet" hose. After circulating through the core, the coolant returns to the water pump through the "outlet" or "return" hose. Both the inlet and outlet return hoses should feel hot when the engine is at normal operating temperature and the heater is on.

      1. If the both heater core hoses were cooled, then this vehicle might have an insufficient coolant in the cooling system.
      2. If the heater core inlet hose is hot and the outlet hose is cool, the heater core might be clogged.

      Note: check the radiator coolant level and top it off as needed.

      B. Some cooling systems have air bleed valves built into the system to aid in the removal of air pockets. Advice: For many cooling systems, the method of removing air pockets is to start the engine and allow it to run with the radiator cap off or loose until all the air escapes from the neck of the radiator. For some systems this method is not sufficient, and the manufacturer has installed air bleed valves usually near or on the thermostat housing.
  • charleneanter
    charleneanter - 2005 Dodge Grand Caravan - Body & Interior - 12/29/2012
    Interior reading light does not light
    we have tried testing with a test light and it is not lighting and it has new bulbs. it won't light if car is running or not running. all other lights work fine but sometimes the keyless remote control will not open car doors and I must remove the fuse and then ...
     
    0 answer
  • baggd85c10
    baggd85c10 - 2003 Dodge Ram 1500 - Body & Interior - 12/29/2012
    I was wondering my 2003 dodge ram 1500 quad cab with lock and unlock the doors by themselves
     
    0 answer
  • baggd85c10
    baggd85c10 - 2003 Dodge Ram 1500 - Body & Interior - 12/29/2012
    I was wondering my 2003 dodge ram 1500 quad cab with lock and unlock the doors by themselves
     
    0 answer
  • frkroberts
    frkroberts - 2004 Dodge Caravan - Body & Interior - 12/27/2012
    Air conditioning only works on high
    The air,heat, defrost all only work on high. All other speeds get no air but high works fine
     
    • Jason
      12/27/2012 Jason
      Replacing the blower motor resistor is the most common fix. I think its behind the glove box.
  • mckenzie.hellman
    mckenzie.hellman - 2001 Dodge Neon - Body & Interior - 12/26/2012
    What year dodge neon hoods will fit a 2004 front end?
    I have an 01 dodge neon with a 04 front end. Someone shoved their trailer hitch into my hood when they backed into me. I have found every year from 2000+ EXCEPT a 04.
     
    • Jimm
      12/26/2012 Jimm
      Try the many on-line auto parts sources, such as; www.autopartswarehouse.com or www.rockauto.com for the replacement parts. You can also compare the body parts listings and numbers / applications for various years.
  • mckenzie.hellman
    mckenzie.hellman - 2001 Dodge Neon - Body & Interior - 12/26/2012
    What year dodge neon hoods will fit a 2004 front end?
    I have an 01 dodge neon with a 04 front end. Someone shoved their trailer hitch into my hood when they backed into me. I have found every year from 2000+ EXCEPT a 04.
     
    • Jimm
      12/26/2012 Jimm
      Try the many on-line auto parts sources, such as; www.autopartswarehouse.com or www.rockauto.com for the replacement parts. You can also compare the body parts listings and numbers / applications for various years.
  • jerry
    jerry - 1995 Dodge Ram 1500 - Body & Interior - 12/24/2012
    Replace headliner
    Torn
     
    • Jimm
      12/24/2012 Jimm
      Need more information - is there a question in regard to how to replace the headliner? Is there a question in regard to the relative cost? Please post a reply and phrase the issue you are having in the form of a question for further assistance.
      Jimm
      12/24/2012 jerry
      Headliner material is old and falling down. Need info on replacing technique. I will DIY. Would appreciate tips on type of glue and source for material.
  • jreed1
    jreed1 - 2001 Dodge Dakota - Body & Interior - 12/22/2012
    ALL gauges stop working all at once is there a fuse i should check
    We had dash apart to see if everthing was still connected
     
    • Bill
      12/22/2012 Bill
      Disconnect neg battery terminal for a few minutes then reconnect to re-boot computer ECU
  • sdbabyboomers
    sdbabyboomers - 1995 Dodge Ram 2500 - Body & Interior - 12/21/2012
    Do you send parts to australia
    headlightson both sides
  • tinadrama
    tinadrama - 2008 Dodge Grand Caravan - Body & Interior - 12/19/2012
    Wipers wont turn off, front windows wont work and dash lights blink. What is wrong?
     
  • franno
    franno - 1998 Dodge Dakota - Body & Interior - 12/17/2012
    Heater core how to install
    Not working
     
    • CVO
      12/17/2012 CVO
      Was it plugged ?
      Try this tip.

      A. Insufficient coolant , trapped air in the cooling system might not have enough coolant to fully fill the heater core.
      The hot coolant flows from the engine to the heater core through the "inlet" hose. After circulating through the core, the coolant returns to the water pump through the "outlet" or "return" hose. Both the inlet and outlet return hoses should feel hot when the engine is at normal operating temperature and the heater is on.

      1. If the both heater core hoses were cooled, then this vehicle might have an insufficient coolant in the cooling system.
      2. If the heater core inlet hose is hot and the outlet hose is cool, the heater core might be clogged.

      Note: check the radiator coolant level and top it off as needed.

      B. . Some cooling systems have air bleed valves built into the system to aid in the removal of air pockets. Advice: For many cooling systems, the method of removing air pockets is to start the engine and allow it to run with the radiator cap off or loose until all the air escapes from the neck of the radiator. For some systems this method is not sufficient, and the manufacturer has installed air bleed valves usually near or on the thermostat housing.

      If it was a bad heater core, see this repair guides for the replacement.

      http://www.autozone.com/.../...rGuideContent.jsp
  • vesnac5
    vesnac5 - 1993 Dodge B250 - Body & Interior - 12/15/2012
    1993 dodge b250 wiper motor replacement
     
    • Jimm
      12/15/2012 Jimm
      Access the wiper motor from underneath and behind the instrument panel. Remove the wiper linkage connection from the motor shaft. Remove the wiper motor wiring connection. Unbolt the three (3) bolts holding the wiper motor in place. Remove the wiper motor.

      The installation is the reverse of the removal. Try the many on-line auto parts sources; such as - www.autopartswarehouse.com or www.rockauto.com for the replacement parts. For example, they (RockAuto) list the wiper motor for around $43.00 for your vehicle.
  • vesnac5
    vesnac5 - 1993 Dodge B250 - Body & Interior - 12/15/2012
    1993 dodge b250 wiper motor replacement
     
    • Jimm
      12/15/2012 Jimm
      Access the wiper motor from underneath and behind the instrument panel. Remove the wiper linkage connection from the motor shaft. Remove the wiper motor wiring connection. Unbolt the three (3) bolts holding the wiper motor in place. Remove the wiper motor.

      The installation is the reverse of the removal. Try the many on-line auto parts sources; such as - www.autopartswarehouse.com or www.rockauto.com for the replacement parts. For example, they (RockAuto) list the wiper motor for around $43.00 for your vehicle.
 
AutoMD Verified Customer
AutoMD obtained proof this customer interacted with the shop.