Auto Answers » Brakes » Chrysler

Chrysler brakes repair questions and answers

Post your Chrysler brakes question or share what you know by answering questions

34 Questions
Sort by:
  • Corry
    Corry - 1999 Chrysler Town & Country - Brakes - 9/20/2014
    How do I remove the brake booster?
    I have the retaining bolts off, the master cylinder off but I can not get it out of the engine compartment.
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2000 Chrysler 300M - Brakes - 7/7/2014
    Long peddle travel after booster replacement
    Brakes worked fine on the wife's car until the brake booster failed. Had the booster replaced. I drove it a day or two later and noticed a soft/spongy peddle/ a lot of peddle travel. Mechanic said that master cylinder was bad. Had the master replaced and the brake ...
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2000 Chrysler 300M - Brakes - 7/7/2014
    Long peddle travel after booster replacement
    Brakes worked fine on the wife's car until the brake booster failed. Had the booster replaced. I drove it a day or two later and noticed a soft/spongy peddle/ a lot of peddle travel. Mechanic said that master cylinder was bad. Had the master replaced and the brake ...
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2003 Chrysler 300M - Brakes - 6/18/2014
    Several brake related issues
    I have a slight shudder when I apply the brakes on the ride to work (60 miles expressway). On the ride home, after about 20 miles, the shudder turns severe. Then I feel a vibration for about 5-10 miles without applying the brakes and a simple touch of the brake ...
     
    0 answer
  • Billy
    Billy - 2004 Chrysler Pacifica - Brakes - 6/17/2014
    Brakes boggy after replacing brake pads
    replaced brake pads on front and rear... never broke into brake lines, just opened brake fluid reservoir so could push pistons back into place. didnt pull off rotors, in good shape. now brakes are kinda boggy... is there air in lines? I'll havta take to a shop to ...
     
    0 answer
  • athena
    athena - 1987 Chrysler Fifth Avenue - Brakes - 6/3/2014
    What is causing my brake pedal to have barely any pressure?
    I just changed my master cylinder, my front brakes and calipers, we bled the brakes, and there is no leaking
     
    0 answer
  • AutoMD Member
    AutoMD Member - 1999 Chrysler Concorde - Brakes - 5/25/2014
    2 brake lines from master cylinder & 1 from left front wheel. Where does each line go?
    All go to A block behind left front fender but what hole in block does each line go to?
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2007 Chrysler Town & Country - Brakes - 5/24/2014
    Hat do I need to replace master cylinder on 2007 Chrysler
    Front brake pad rotor and master cylinder
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2008 Chrysler Pacifica - Brakes - 4/30/2014
    Problems with abs system
    Had abs scanned pulled a c121e code brake pressure sensor where is this sensor located?
     
    0 answer
  • AutoMD Member
    AutoMD Member - 2006 Chrysler Pacifica - Brakes - 3/18/2014
    The rear passager brake locks up when I change gear into Drive. How do I release the brake?
    I always put parking brake on when I leave my car in a public area. I released the parking brake it reversed just fine bit when I changed gear into drive it locked up right way. What could be the issue and what's the quickest way to fix so I can get my car home to ...
     
    0 answer
  • charlie ardite
    charlie ardite - 1991 Chrysler New Yorker - Brakes - 11/5/2013
    Front pass.side front wheel bearing ys grinding
    yt sounds like the wheel may fall off
     
    0 answer
  • charlie ardite
    charlie ardite - 1991 Chrysler New Yorker - Brakes - 11/5/2013
    Passenger side front wheel bearing is making much noise
    ,aking much noise grinding, may be cv joint ?
     
    0 answer
  • jubbie7
    jubbie7 - 2006 Chrysler Pacifica - Brakes - 8/28/2013
    How do I unlock my disc brakes??
    I was driving the car with the park brake still engaged, I disengaged the park brake while driving and my rear passenger wheel locked up.
     
    0 answer
  • jubbie7
    jubbie7 - 2006 Chrysler Pacifica - Brakes - 8/28/2013
    How do I unlock the disc brake pads?
    I was driving the car and forgot I had the parking brake engaged. I unlocked the parking brakes while driving and the right rear wheel is locked.
     
    0 answer
  • sjd
    sjd - 2012 Chrysler 300 - Brakes - 4/25/2013
    When brake is applied a thunk sound happens.
    happens when stop fast, slow pumping stop or slow gradual stop. dealer cannot find what is wrong. mileage 500. miles just bought it.sound is in back of car. checked brakes, tire holder, etc.. the bottom of the door on right side very bottom trim needs to be ...
     
    0 answer