Auto Answers » Body & Interior » Chrysler » Page 11

Chrysler body & interior repair questions and answers

Post your Chrysler body & interior question or share what you know by answering questions

830 Questions
Sort by:
  • planohog
    planohog - 2001 Chrysler PT Cruiser - Body & Interior - 11/15/2012
    My sunroof is "off track", still operates, does not leak, but I am fearful of opening it as it may not close, in my
    opinion. The dealership quoted me $1500 to replace. How do I know, and who can I trust, to insure the sumroof operates as it should? Again, the electric motor works just fine. Thank you.
    0 answer
  • Stewal
    Stewal - 1998 Chrysler Sebring - Body & Interior - 11/12/2012
    Power door locks inoperable
    Door locks don't work properly and need repair
    0 answer
    XFBLACK - 2004 Chrysler Crossfire - Body & Interior - 11/12/2012
    How to fix ashtray mechanism in 2004 chrysler crossfire
    Ashtray won't close
    0 answer
  • savingumoney
    savingumoney - 2007 Chrysler Crossfire - Body & Interior - 11/10/2012
    Left Window Blows 40 amp fuse when you hit the control button for up and down
    Removed Door panel and worked the window with aulx. power source with 11 amp fuse. Window Worked just fine without blowing the fuse. Mechanic is say BAD B.C.M. Bode Control Module. Cost $ 1,960.00 / $ 2,400.00 with pasrt and labor?
    0 answer
  • AprilAiken
    AprilAiken - 2002 Chrysler Sebring - Body & Interior - 11/8/2012
    Someone ran on a curb and knocked off a black piece off the bottom of the right side of my car. Plzz help
    My car sits really low in the front like most Chrysler sebrings and im not sure what the piece is and i am very concerned. She went into drive instead of reverse and drove my car onto a walkway and knocked a big black piece off under the bottom of the car and ...
    0 answer
  • rlagoe
    rlagoe - 2007 Chrysler Town & Country - Body & Interior - 11/7/2012
    Lookinng for the overhead reading light brackets for a 2007 Town & Country LX
    These are the lights that are over the dashboard on each side of the tempertureand mpg indicator and flanked by the visors.
  • chris
    chris - 2003 Chrysler Town & Country - Body & Interior - 11/1/2012
    My front windshield wiper works intermittent
    Always works on high hardly ever on low
    0 answer
  • chris
    chris - 2003 Chrysler Town & Country - Body & Interior - 11/1/2012
    My back windshield wiper does not work
    Back windshield wiper does not work
    0 answer
  • dscentair
    dscentair - 1999 Chrysler Town & Country - Body & Interior - 10/30/2012
    Heater blows cold on passenger side?
    A/C works great out of all vents. Heater blows hot in all vents except front passenger, ice cold. No obstructions, reset codes no errors. Any ideas?
    0 answer
  • KayceDalessandro
    KayceDalessandro - 2009 Chrysler Sebring - Body & Interior - 10/29/2012
    Parts needed to replace front bumper and fender after small front end collision?
    0 answer
  • jmm457
    jmm457 - 2004 Chrysler Crossfire - Body & Interior - 10/29/2012
    When I put the key in I can not start the car some times.
    If I jiggle the key in the ignition sometimes it will catch and start.
    • CVO
      10/29/2012 CVO
      First, check the battery and starter cables for their tightness or free of corrosion and physical damaged.

      See this Starting system simplified diagram. Have a help from an assistant to crank the engine, use a 12 volt light tester or a digital voltmeter, apply it to the starter control circuit.
      If there is light or 12 volts and the starter isn't cranking, then the starter is the culprit. Have the starter to bench test for free at the local auto parts stores.
      If there isn't no light or no volts, then the ignition switch is the culprit.

      Note: a 3/4 charge battery is 12.50 volts
      A discharge battery is 11.75 volts.
      A battery under a cranking load and it is reading less than 7 volts,it will be a recycled ( junk ) battery.
  • thompkinseric010
    thompkinseric010 - 1992 Chrysler New Yorker - Body & Interior - 10/29/2012
    Front headlight cover is not working
    0 answer
  • avais11
    avais11 - 1998 Chrysler Sebring - Body & Interior - 10/29/2012
    0 answer
  • hwledesc
    hwledesc - 2002 Chrysler 300M - Body & Interior - 10/25/2012
    Blower motor not blowing
    0 answer
  • Jean
    Jean - 1999 Chrysler Sebring - Body & Interior - 10/15/2012
    Heater air is warm at idle but cools when driving.
    OD: 240,000 I have had the thermostat and water pump replaced. Also the heater core has been flushed. When the car is sitting at idle speed the air from the heater is warm. When you turn the blower motor beyond low and are driving the air becomes cool. I had taken ...
    • CVO
      10/15/2012 CVO
      A. Insufficient coolant , trapped air in the cooling system might not have enough coolant to full fill the heater core.

      The hot coolant flows from the engine to the heater core through the "inlet" hose. After circulating through the core, the coolant returns to the water pump through the "outlet" or "return" hose. Both the inlet and outlet return hoses should feel hot when the engine is at normal operating temperature and the heater is on.

      1. If the both heater core hoses were cooled, then this vehicle might have an insufficient coolant in the cooling system.
      2. If the heater core inlet hose is hot and the outlet hose is cool, the heater core might be clogged.

      Note: check the radiator coolant level and top it off as needed.

      Some cooling systems have air bleed valves built into the system to aid in the removal of air pockets. Advice: For many cooling systems, the method of removing air pockets is to start the engine and allow it to run with the radiator cap off or loose until all the air escapes from the neck of the radiator. For some systems this method is not sufficient, and the manufacturer has installed air bleed valves usually near or on the thermostat housing.

      B.The blend door actuator is a servo responsible for controlling the mix of warm air from the heater core and cool air from the A/C and outside. If it malfunctions, your climate control system may not respond properly when you change the temperature on the climate control system.

      See this repair guide for the blend door actuator.