Auto Answers » View Question
larry
larry 3/23/2013
1998 Ford Ranger XLT 4Cyl2.5L - Engine
my obd meter gave me 2 codes p0171 and p1131 whats my problem
1 Answer
  • Jimm
    Jimm 3/23/2013
    P0171 = System Too Lean (Bank 1)
    Basically this means that an oxygen sensor in bank 1 has detected a lean condition (too much oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine that has cylinder #1. The P0171 is one of the more common trouble codes.

    This code is triggered by the first downstream (front) O2 sensor. The sensor provides a reading of the air:fuel ratio leaving the engine's cylinders, and the vehicles powertrain/engine control module (PCM/ECM) uses that reading and adjusts to keep the engine running at that optimum ratio of 14.7:1. If something is not right and the PCM cannot maintain the 14.7:1 ratio, but rather there is too much air, it triggers this code.

    A code P0171 may mean that one or more of the following has happened:
    •The MAF (Mass Air Flow) Sensor is dirty or faulty
    Note: The use of "oiled" air filters may cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
    •There could be a vacuum leak downstream of the MAF sensor
    •Possible cracked vacuum or PCV line/connection
    •Faulty or stuck open PCV valve
    •Failed or faulty oxygen sensor (bank 1, sensor 1)
    •Sticking/plugged or failed fuel injector
    •Low fuel pressure (possible plugged/dirty fuel filter!)
    •Exhaust leak between engine and first oxygen sensor

    Possible Solutions:
    A lot of times, cleaning the MAF sensor and finding/fixing vacuum leaks fix the problem. If you're on a tight budget, start there, but that may not be the fix for certain. So, possible solutions include:
    •Clean the MAF sensor. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
    •Inspect all vacuum and PCV hoses, replace/repair as required
    •Inspect all hoses and connections in the air intake system
    •Inspect and/or test the intake manifold gaskets for leakage
    •Check for a dirty fuel filter and proper fuel pressure
    •Ideally you'll want to monitor short and long term fuel trims using an advanced scan tool
    •If you have access, you may want to run a smoke test

    P1131 = Insufficient switching oxygen sensor, bank 1, sensor 1

    Replace the oxygen (O2) sensor(s) - on both banks at the seame time due to mileage, wear, age considerations.
    Here are several possible on-line auto parts sources; www.autopartswarehouse.com, www.1aauto.com, www.rockauto.com - to check the various part numbers and applications. For example, they (RockAuto) list the oxygen sensor (both upstream and downstream) from around $19.70 each for your vehicle.
    Reply
    0
close

Preview Answer