Auto Answers » View Question
BMW1Addict
BMW1Addict 4/1/2012
2009 BMW 135i Base 6Cyl3.0L - Body & Interior
How do I clean the inside of the headlight lens
there was water in the headlight so i took an airhose and blew it all out now there dirt stuck on the inside and it seems like its held on by a seal
1 Answer
  • EG9 K20A3
    EG9 K20A3 4/3/2012
    If condensation is getting into your headlights, and there are no visible cracks or damage, there’s likely a problem with a seal, gasket or a drainage hole. In some states, waterlogged headlights won’t pass inspection. Even if you take the lenses off and dry them, the problem is likely to reoccur unless you replace all of the components.

    If you’ve got a lot of water built up in your headlights, the easiest way to clear it out and keep them clear is to drill a very small hole at the bottom-most part of the headlight so water can drain. If it’s just a little condensation, the following method might work:
    You Will Need:

    * Silica Gel Packs
    * Tools required to remove your headlight assembly (see your owner’s manual)
    * Lint free cloth

    Steps to Remove the Condensation:

    1. Consult your vehicle owner’s manual to determine how to access the headlight assembly. Follow the instructions to gain access. This is usually accomplished by opening the hood and removing the back of the assembly or unscrewing the bulb.
    2. If you can reach inside the assembly, use a lint free cloth to wipe the moisture from inside the lens. If not, you can skip this step.
    3. Drop a silica gel pack inside the lens assembly making sure it doesn’t come into contact with the bulb.
    4. Put the headlight back together.

    Additional Tips and Advice

    * You can use any silica gel packs. They are often included in new product packaging and are commonly found in white, cloth-like bags with the written message “DO NOT EAT.”
    * Make sure the gel pack does not lie in direct contact with the bulb. If there’s not enough clearance for it to sit on the bottom of the assembly without coming into contact with the bulb, do not attempt to leave it there.
    * Silica packs will absorb up to 40% of their weight in water. This will take care of most of the condensation in your lenses, however, it will not solve the problem. To fix the problem, you will need to replace the gaskets, seals, apply silica gel to all of the seams of the assembly or replace the assembly with a new one.
    * If you are required to have annual vehicle inspections, you will likely have to replace the headlight before your car will pass inspection.
    * Silica is nontoxic, nonflammable and nonhazardous.
    Reply
    0
close

Preview Answer

 
AutoMD Verified Customer
AutoMD obtained proof this customer interacted with the shop.