Auto Answers » View Question
Don
Don 5/31/2010
2002 GMC Sierra 2500 HD SLT 8Cyl8.1L - Engine
A/C cooling isn't very cold. New compressor, drier, orfice valve replaced. Showing about 55 degrees at vent on a 80 degr
1 Answer
  • Nissan Technical Advisor
    The evaporator could be blocked by the trapped dust and dirt. The evaporator for the central air system is located directly above the furnace in the plenum. The evaporator may not be accessible, but if it is, you should clean it once a year. If the plenum has foil-wrapped insulation at its front, you can clean the evaporator; if the plenum is a sealed sheet metal box, do not attempt to open it. Here's how to clean an accessible evaporator: Remove foil-wrapped insulation at front of plenum; it's probably taped in place. Remove tape carefully, because you'll have to replace it later. Behind insulation is access plate, which is held in place by several screws. Remove screws and lift off plate. Clean entire underside of evaporator unit with stiff brush. A large hand mirror can help you see what you're doing. If you can't reach all the way back to clean entire area, slide evaporator out a little. Evaporator can be slid out even if it has rigid pipes connected to it, but be careful not to bend pipes. Clean tray below evaporator unit. This tray carries condensation away from evaporator. Pour 1 tablespoon of household bleach into weep hole in tray to prevent fungus growth. In extremely humid weather, check condensate drain and pan every other day. If there's much moisture in pan, weep hole from pan to drain line may be clogged. Open weep hole with piece of wire. Put unit back into place, reinstall plate, and tape insulation back over it. Turn back on air conditioner, and check for air leaks. Seal any leaks with duct tape.
    You also may need to clean the condenser to get your air conditioning functioning properly.
    Reply
    0
close

Preview Answer

 
AutoMD Verified Customer
AutoMD obtained proof this customer interacted with the shop.